Toro GreenKeeper 212 Manuel d'utilisateur télécharger pdf (Page 26)

(Optional)

CAUTION: To prevent controller damage,

ensure the relay current draw does not exceed

0.35 Amps. Do not connect the controller

directly to the pump starter.

1. Route a wire pair from the pump relay into the con-

troller housing.

2. Connect one wire to the terminal labeled COM (12).

Connect the remaining wire to the terminal labeled

PUMP/MV (13) as shown below.

CAUTION: To prevent pump damage due to

“dead-heading”, connect a jumper wire from any

unused station terminal to a station terminal with

a valve connected.

Note: For model GK212-26-04, contact your Toro dis-

tributor for the recommended transformer.

CAUTION: Do not plug the transformer into an

electrical outlet until all of the wiring procedures

have been completed.

1. Route the cable from the transformer (17) through the

small opening provided in the base of the housing.

Wrap the cable around the post as shown below.

2. Connect one transformer cable wire to each terminal

labeled 24 VAC (14). The wires can be connected to

either terminal.

Connecting The TransformerConnecting A Pump Start Relay

234

678

234

678 9

BATTERY

Pump Relay Valve Common Wire

Jumper Wire

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 35 36

Pas de commentaire

Toro GreenKeeper 212 Manuel d'utilisateur Page 26